Solution to Trouble Trouble of Ultra - fine Milling Machine2019-09-02 10:31:28

Summary:Ultra-fine grinding is a kind of ultra-fine grinding in the use of common faults, may be the design of the machine itself, but more is due to improper use of the operation. The main reasons for the congestion problem may have the following.

Too tired to read? Try staff service!

Engineer one-to-one for you, draw up plans in time, and provide investment estimates in time!

Get Price Staff Service

Solution to Trouble Trouble of Ultra - fine Milling Machine

Ultra-fine grinding is a kind of ultra-fine grinding in the use of common faults, may be the design of the machine itself, but more is due to improper use of the operation. The main reasons for the congestion problem may have the following:

1, the discharge pipe is blocked or blocked too fast, will make the ultrafine mill air plug; and the transmission device mismatch will produce discharge tube wind weakened or calm after the blockade. Found that the fault should be clear to send the port change the transmission device does not match, adjust the feed speed, so that the normal operation of equipment.

2, hammer, aging, screen hole closed, ragged, broken material moisture content is too high will make ultra-fine grinding block. Should regularly update and aging serious broken hammer, ultra-fine grinding good working condition, and regularly check the screen, wet material crushing rate should be less than 14%, can improve production efficiency, and make ultrafine mill is not blocked, improve the ultra-fine grinding work reliability. Superfine crushing method to solve the clogging fault.

3, feed rate, load increases, causing clogging. In the feeding process, pay attention to the ammeter pointer deflection angle, if more than the rated current, indicating that the motor overload, prolonged overload, burn the motor. This situation should immediately reduce or close the discharge gate, you can also change the way the feed, by increasing the feeder to control the amount of feed. The machine is manual, automatic two, the user should be based on the actual situation to choose the appropriate feeding. Ultra-fine high-speed, load, and load fluctuations. Therefore, the current ultra-fine grinding of the general control of the work in the rated current of 85%.

Paper jam failure superfine grinding process in the process of ultra-fine grinding often encountered, encountered this situation, we can use the above method to solve.

Request a Quotation

HOT PRODUCTS