How to reduce the wear of ultra-fine grinding ring2019-09-02 10:27:37

Summary:Ultra-fine grinding rings and rollers are relatively easy to wear abrasive parts. These two parts are usually in direct contact with hard ore. This will bring the user's economic losses..

Too tired to read? Try staff service!

Engineer one-to-one for you, draw up plans in time, and provide investment estimates in time!

Get Price Staff Service

How to reduce the wear of ultra-fine grinding ring

Ultra-fine grinding rings and rollers are relatively easy to wear abrasive parts. These two parts are usually in direct contact with hard ore. This will bring the user's economic losses. Of course, ultrafine mill parts can not avoid parts wear, but we can take two protective measures to reduce the wear rate. The following is a brief analysis of some of the reasons for the wear of parts. Tell you how to reduce the wear of the roller and the grinding ring.

Regular replacement of ultra-fine grinding equipment parts will give users economic losses. Moreover, if it is not replaced, it can not meet the production requirements. This gives the user endless trouble. Now, I will introduce two factors and methods to reduce the wear of the roller and the grinding ring.

Hardness material

If the hardness of the treated material is very high, this will inevitably exacerbate the "wear rate" of the abrasive part and cause the equipment to be scrapped in advance. In the production process, the user should refer to the instructions, and select the appropriate material to ensure a reasonable working environment.

 

The material is mixed with irreversible impurities

If the material contains two more difficult to wear impurities, ultrafine mill can not be grinding them, so that they continue to cycle in the mill grinding, which will accelerate the wear parts of the grinding speed.

 

Superfine wear parts

Material properties are important, but the abrasive material texture is also crucial. Grinding rings and rollers must use relatively high quality steel. The use of low-grade steel parts wear rate quickly, perhaps, users need to use 1-2 months to replace. Which will lead to the user's economic losses. Manganese steel is more suitable for the use of materials to create grinding and grinding ring, because of their special nature, can improve the use of equipment time.

The above is the main factor affecting the wear speed of the roller and the grinding ring. In the production process, if you do not pay attention to these aspects, I believe it will greatly extend the life of the grinding machine, and reduce the frequency of replacement parts. After comparison, will be directly for the user to bring economic benefits.

Request a Quotation

HOT PRODUCTS